When measuring blood pressure first clear tapping sound What does it mean?

Hi, I want to ask a question about blood pressure sounds. When taking blood pressure I hear a heart beat at 140mmHg but just one heart beat and then it stops. Then I hear another heart beat start at 110mmHg and it is consistent. My question is this: Is the 140mmHg my systolic number or is the first beat of a consistent set of beats my systolic number?

I have been told the first sound, then in school I was told the first consistent heart beat sound is the systolic number. I am a little confused and considering there is a 30mmHg difference I feel this is a very important consideration for me to have made clear by a professional before I am considered a professional. Thank you for your time.

Submitted by Christopher from Indiana on 08/04/2014

Answer:

Dear Christopher,
Below is a method that I use to measure blood pressure. You can find further information in most textbooks of Physical Diagnosis.

Technique of Measuring Blood Pressure

1. The subject should be sitting in chair with his feet on the floor (sitting with the legs hanging off of the examination table will falsely raise the blood pressure).
2. Apply the fully deflated cuff snugly around the upper arm and place the marked area over the inside (medial) aspect of the elbow which is over the brachial artery.
3. While palpating the radial pulse, inflate the cuff and note the pressure reading at the point the pulse is extinguished. This estimates the systolic blood pressure.
4. Apply the stethoscope over the brachial artery above the elbow joint just below the cuff.
5. Inflate the cuff to a reading which is at least 15 mmHg above where the pulse was extinguished. Inflating the cuff too rapidly to high pressures may cause discomfort and result in a temporary increase in the pressure over the baseline.
6. Listen for the onset of the Karotkoff sounds which is the systolic pressure.
7. Drop the pressure slowly (2 mmHg per beat) until the sounds disappear. This is the diastolic pressure.

Points to Remember:

An alternate method is to arbitrarily pump the cuff to 200 mmHg and listen for the sounds. This is not recommended because (1) It may cause pain. (2)The pressure may actually be higher than 200 and one could have inflated to the level of the ‘auscultatory gap’ which is a pressure range in some patients where the sounds may actually temporarily disappear which can cause significant underestimation of the systolic pressure.

If you hear an occasional sound at the beginning of step 6 above, it could be do to a variation of the pressure of a single beat which is common in the presence of an irregular heart beat. Repeat the measurement until you get a clear reading during a period regular rhythm (if possible). Accurate measurement of the blood pressure by this technique depends on the presence of a regular rhythm. In patients with frequent premature beats and atrial fibrillation, the pressure varies from beat to beat. By auscultation, one can better estimate the pressure. Digital devices essentially measure one systolic and one diastolic pressure and assume the rhythm is regular. The varying RR intervals will often lead to inaccurate readings of both the blood pressure and the pulse. The digital pressure recording should not be trusted in the presence of an irregular rhythm.

In patients with severe respiratory distress (eg., asthma) or pericardial tamponade, the pressure will vary significantly with the respiratory cycle (pulsus paradoxus). The degree of paradox is the pressure difference from the onset of all sounds to the appearance of sounds during the entire respiratory cycle (consistent sounds). A paradox reading of >10 mmHg is considered abnormal.

Finally, in some individuals, one can hear Karotkoff sounds close to zero. In this case, the point at which the sounds become muffled is considered the diastolic pressure. It is appropriate to give 3 readings in this situation. For example: 130/70/15 or 150/70/0.

One last point: When measuring the pressure in a patient for the first time, measure it in both arms. A consistent difference of >10 mmHg is a sign of possible arterial obstruction which may need to be investigated. The correct pressure is obviously in the arm with the highest reading.

Those who measure blood pressure should be familiar with the practical points listed and discussed below.

Practical points

The observer should outline the procedure briefly. In particular, he or she should warn the patient of the minor discomfort caused by inflation and deflation of the cuff and tell the patient that the measurement may be repeated several times.

In many patients blood pressure is always higher when measured by doctors (and nurses) - this is the phenomenon of "white coat hypertension". Readings are likely to be lower when they are taken in the home or by ambulatory blood pressure measurement (ABPM).

24 h ABPM confirms the presence of white coat hypertension in this patient

Explanation of ABPM plots

The defence reaction is the rise in blood pressure associated with the anxiety of measurement. This increase in blood pressure tends to subside once the patient becomes accustomed to the procedure and to the observer.

Changes in drug treatment should not be made on the basis of one measurement of blood pressure but rather on the patterns of blood pressure change during a period of observation. In many patients blood pressure levels fall without treatment.

Blood pressure varies in individuals according to the time of day, meals, smoking, anxiety, temperature, and the season of the year. It is usually at its lowest during sleep.

Whether the patient is sitting or lying (supine) makes no difference to the blood pressure readings, provided that the arm is in the correct position. However, pressure should also be measured in the standing position in patients whose symptoms or drug regimen may be associated with a disproportionate postural fall. Pregnant patients may suffer a profound fall in blood pressure when lying supine; therefore in pregnancy all measurements should be performed with the patient either sitting or in the left lateral position. No information is available on the optimal time to be spent in a particular position before the measurement. We suggest 3 min lying or sitting and 1 min standing.

The patient should be in a warm environment. Tight or restrictive clothing should be removed from the arm. A simple measure is to request that patients wear a loose fitting, short sleeved garment when attending for blood pressure measurement.

The position of maximal pulsation of the brachial artery in the arm, just above the antecubital fossa, may be marked lightly with a pen. A cuff with a long enough bladder should then be applied to the upper arm. As contact of the stethoscope with the tubing of the cuff may produce artefactual sounds, the tubing from the blood pressure cuff should not cross the auscultatory area. The centre of the bladder should be positioned over the line of the artery. The lower edge of the bladder should be 2-3 cm above the marked point. The cuff should fit firmly and comfortably and be well secured.

The arm should be horizontal and supported at the level of the mid-sternum because dependency of the arm below heart level leads to an overestimation of systolic and diastolic pressures of about 10 mm Hg. Correspondingly, raising the arm above heart level leads to underestimation of these pressures.

The mercury column of the sphygmomanometer must be vertical, at eye level, and not more than 3 feet from the observer. Stand mounted manometers are recommended, largely because they are mobile and easily adjusted for height. Box and desk models are more easily damaged and less convenient to use.

The systolic pressure should be estimated before the operator uses the stethoscope by palpating the brachial artery pulse and inflating the cuff until the pulsation disappears. The point of disappearance represents the systolic pressure. This measure is especially useful in patients in whom auscultatory end points may be difficult to judge accurately - for example, pregnant women, patients in shock, or those taking exercise.

The stethoscope is placed gently over the artery at the point of maximal pulsation. It must not be pressed too firmly or touch the cuff, or the diastolic pressure may be underestimated. The pressure is then raised by inflating the bladder to 30 mm Hg above the systolic blood pressure as estimated by palpation. Next the pressure is reduced at 2-3 mm Hg per second. The point at which repetitive, clear tapping sounds first appear for at least two consecutive beats gives the systolic blood pressure. The point where the repetitive sounds finally disappear gives the diastolic blood pressure (phase 5). Both measurements should be taken to the nearest 2 mm Hg to avoid .

Auscultatory sounds

• Phase 1 The first appearance of faint, repetitive, clear tapping sounds that gradually increase in intensity for at least two consecutive beats is the systolic blood pressure.
• Phase 2 A brief period may follow during which the sounds soften and acquire a swishing quality.
• In some patients sounds may disappear altogether for a short time.
• Phase 3 The return of sharper sounds, which become crisper to regain, or even exceed, the intensity of phase 1 sounds. The clinical significance, if any, of phases 2 and 3 has not been established.
• Phase 4 The distinct, abrupt muffling sounds, which become soft and blowing in quality.
• Phase 5 The point at which all sounds finally disappear completely is the diastolic pressure.

Summary of blood pressure measurement

Palpatory estimation of systolic pressure

1. Palpate brachial artery pulsation.
2. Inflate cuff until pulsation vanishes.
3. Deflate cuff.     
4. Estimate systolic pressure.

Auscultatory measurement of systolic and diastolic pressure

1. Place stethoscope gently over point of maximal pulsation of brachial artery.
2. Inflate cuff to 30 mm Hg above estimated systolic pressure.
3. Reduce pressure at rate of 2-3 mm Hg per second or per pulse beat.
4. Take reading of systolic pressure when repetitive, clear tapping sounds appear for two consecutive beats.
5. Take reading of diastolic pressure when repetitive sounds disappear.

Digit preference, whereby observers choose to record a favourite number, most commonly 0 or 5 mm Hg, is a serious source of bias. It is important to realise that such digit preference may introduce substantial errors that could lead to incorrect decisions being made, especially in patients with borderline blood pressures. Such bias is best avoided by recording systolic and diastolic pressures to the nearest 2 mm Hg.

The silent or auscultatory gap occurs when the sounds disappear between the systolic and diastolic pressures. The importance of the gap is that unless the systolic pressure is palpated first it may be underestimated. The presence of a silent gap should be recorded on the case sheet or blood pressure chart.

It is preferable to take one measurement carefully at each visit, repeating the measurement if there is uncertainty or distraction, rather than to make several hurried measurements. If the blood pressure is elevated above say 140/90 mm Hg, a second reading should be recorded after an interval of at least 1 min. For patients in whom sustained increases of blood pressure are being assessed a number of measurements should be made on different occasions before definite diagnostic or management decisions are made.

Sustained blood pressure elevation

• Repeat measurement at least once at each visit on the same arm.
• Make several measurements at different visits.
• Make each measurement carefully .

The pulse should always be palpated in both arms. A difference between arm pulses may be a clue to coarctation of the aorta, anatomical variants and alterations to the pulse after surgical or cardiological procedures, such as cardiac catheterisation.

Blood pressure should be measured in both arms in all patients with raised blood pressure at the initial assessment. It is suggested that if there is a reproducible difference of 20 mm Hg for systolic pressure and 10 mm Hg for diastolic pressure, decision making should be based on the limb with the higher pressure. Simultaneous measurement in both arms is indicated in patients with suspected coarctation of the aorta where local anatomical abnormalities are suspected.

What to note when measuring blood pressure

• The blood pressure should be written down as soon as it has been recorded.
• Measurements of systolic and diastolic pressure should be made to the nearest 2 mm Hg.
• Pressures should not be rounded off to the nearest 5 or 10 mm Hg (digit preference).
• The arm in which the pressure is being recorded and the position of the subject should be noted, for example, left arm, sitting.
• Pressures should be recorded in both arms on first attendance.
• In obese patients the arm circumference and bladder size should be indicated.
• In clinical practice the diastolic pressure should be recorded as phase 5 except in those patients in whom sounds persist greatly below muffling; this should be clearly indicated, for example 154/68/10.
• If the patient is anxious, restless or distressed, a note should be made with the blood pressure.
• The presence of an auscultatory gap should always be indicated, for example 166/94 (AG from 158 to142).

Coarctation of aorta or suspected anatomical abnormalities

• Measure simultaneously in both arms.

In patients taking drugs that lower blood pressure the measurements may vary depending on the time of day at which the drugs are taken. It may therefore be helpful, when assessing the effect of antihypertensive drugs, to note the time of drug ingestion in relation to the time of measurement.

Patients with high blood pressure should be given a leaflet emphasizing that blood pressure elevation is only one risk factor for cardiovascular disease. Giving up cigarettes, reducing alcohol consumption, weight reduction and dietary restriction of cholesterol and fats may be as important as lowering blood pressure.

What are the sounds you hear when taking blood pressure?

When taking a blood pressure measurement What is the last tapping sound heard?